查看網卡工作速度

[schumi]

http://blog.2be.com.tw/2009/06/linux.html

Linux 如何查看現在網卡是以什麼速度模式工作？？ 10M/100M or 1G

代碼: 選擇全部

# dmesg |grep eth0

divert: allocating divert_blk for eth0
eth0: RealTek RTL8139 at 0xd800, 00:80:48:34:c2:84, IRQ 9
eth0: Identified 8139 chip type 'RTL-8100B/8139D'
divert: freeing divert_blk for eth0
divert: allocating divert_blk for eth0
eth0: RealTek RTL8139 at 0xd800, 00:90:44:34:a5:33, IRQ 9
eth0: Identified 8139 chip type 'RTL-8100B/8139D'
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
eth0: no IPv6 routers present
...

代碼: 選擇全部

# mii-tool -v eth0

eth0: negotiated 100baseTx-FD, link ok
product info: vendor 00:00:00, model 0 rev 0
basic mode: autonegotiation enabled
basic status: autonegotiation complete, link ok
capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD
10baseT-HD
...

代碼: 選擇全部

# ethtool eth0

Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 32
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: p
Current message level: 0x00000007 (7)
Link detected: yes

Here full duplex, half duplex and auto-negotiation have the following meanings.
Full Duplex - Logic that enables concurrent sending and receiving. This is usually desirable and enabled when your computer is connected to a switch.

Half Duplex - This logic requires a card to only send or receive at a single point of time. When your machine is connected to a Hub, it auto-negotiates itself and uses half duplex to avoid collisions.

Auto-negotiation - This is the process of deciding whether to work in full duplex mode or half duplex mode. An ethernet card supporting autonegotiation will decide for itself which mode is the optimal one depending on the network it is attached to.

[schumi]

代碼: 選擇全部

# ethtool -s eth0 speed 10 duplex full autoneg off

[Bhai]

Half Duplex - This logic requires a card to only send or receive at a single point of time. When your machine is connected to a Hub, it auto-negotiates itself and uses half duplex to avoid collisions.